Cisco Firepower 9300 Hardware Installation Manual page 33

Overview
Warning
Use appropriate ESD procedures when inserting the transceiver. Avoid touching the contacts at the rear, and
keep the contacts and ports free of dust and dirt. Keep unused transceivers in the ESD packing that they were
shipped in. The following figure shows a sample SFP transceiver.
Figure 16: SFP
1 Dust plug
Receive optical bore
3
Caution
Although non-Cisco SFPs are allowed, we do not recommend using them because they have not been tested
and validated by Cisco. Cisco TAC may refuse support for any interoperability problems that result from
using an untested third-party SFP transceiver.
The following table lists the Cisco supported transceivers.
Table 8: Supported Cisco SFP/SFP+ and QSFP Transceivers
Optics Type
1 Gb
1G-SX
1G-LH/LX
1G-EX
1G-ZX
1G 1000Base-T
1G 1000Base-T
10 Gb
Supported SFP/SFP+ and QSFP Transceivers
2 Bail clasp
Transmit optical bore
4
PID
GLC-SX-MMD
GLC-LH-SMD
GLC-EX-SMD
GLC-ZX-SMD
GLC-T
GLC-TE
Cisco Firepower 9300 Hardware Installation Guide
29