Cisco Firepower 9300 Hardware Installation Manual page 68

Install, Remove, and Replace the Single-Wide Network Module
Note Verify that you have the correct ROMMON on the Supervisor to support hot swapping. For instructions
on how to verify your firmware package version and to upgrade the firmware if necessary, see the
Firepower 4100/9300 FXOS Firmware Upgrade
To remove and replace the network modules that do not currently support hot swapping, power off the chassis,
replace the network module, and then power the chassis back on.
Note
Verify that you have the correct ROMMON on the Supervisor to support the 100-Gb network modules
(FPR9K-NM-4X100G and FPR9K-NM-2X100G). For instructions on how to verify your firmware package
version and to upgrade the firmware if necessary, see the
Guide.
The following figure shows the front panel of the 10-Gb nonhardware bypass network module. The location
of the captive screw, ports, and LEDs is shown. See
about the other single-wide network modules.
Figure 42: Firepower Network Module 10 Gb
1 Captive screw/handle
3 Ethernet X/3
Ethernet X/7
5
7 Ethernet X/4
Cisco Firepower 9300 Hardware Installation Guide
64
Installation, Maintenance, and Upgrade
Guide.
Cisco Firepower 4100/9300 FXOS Firmware Upgrade
Network Modules, on page 15
2 Ethernet X/1
4 Ethernet X/5
Ethernet X/2
6
8 Ethernet X/6
Cisco
for more information