Getting Connected - VocoPro IR-9000 Owner's Manual

Getting Connected

Connecting the Power Supplies
The IR-9000 includes two power supplies, one for the receiver unit (AC 110V) and one for the microphone charger (AC
110V).
Surge Protector Recommended
VocoPro recommends that you use a surge protector with all of your products to prevent damage caused by unpredictable
power surges. Damage to your unit caused by a power surge may void the warranty.
Connecting Power to the Receiver Unit (Fig. A)
NOTE: Make sure the receiver unit is turned off before connecting the power
Using the AC 110V - DC 15V 500mA power supply
1. Connect the AC end to a surge protector / power strip
2. Connect the other end to the DC input on the rear panel of the receiver unit
(Fig. A)
Connecting Power to the Microphone Charger (Fig. B)
Using the AC 110V - DC 9V 800mA power supply
1. Connect the AC end to a surge protector / power strip
2. Connect the other end to the DC input on the back of the microphone charger
(Fig. B)
8