Getting Connected - VocoPro UHF-5816 Owner's Manual

Getting Connected

The UHF-5816 can be connected to a mixer or amplifier in two ways . There are the dedicated XLR channel
outputs that handle the audio signal independently, or there is the 1/4" mixed output that sends all the mic
signals through a single cable . Use whichever method that suits your needs and equipment .
CONNECTING POWER
Connect the included power supply from the power outlet to Power Input located on the back of the UHF-
5816 receiver .
USING THE XLR OUTPUTS
The XLR outputs allow you to connect each channel to the mixer independently . This gives you more control
over the individual microphone channels when connected to a mixer .
You'll Need:
• UHF-5816
• 4 XLR Patch Cables (not included)
• An input device, such as a mixer or
amplifier (not included)
TO CONNECT THE XLR OUTPUTS:
1 . Ensure the main power switch on the
front panel is turned off .
2 . Connect one end of an XLR cable to the
CH . 1 output of the UHF-5816 .
3 . Connect the other end of the XLR cable to the desired input on your mixer .
Note: To avoid confusion, it's recommended that the XLR jacks are attached correspondingly (e.g. CH.1 to CH.1, CH.2 to CH.2, etc.
as shown).
4 . Repeat steps 2 and 3 until all the XLR outputs are connected .
USING THE 1/4" MIXED OUTPUT
The 1/4" mixed output is useful if you do not have a mixer or if you have limited inputs available on your
mixer . All four microphone signals are mixed together in this output .
You'll need:
• UHF-5816
• (1) ¼" patch cable (included)
• An input device, such as a mixer or
amplifier (not included)
TO CONNECT THE 1/4" OUTPUT:
1 . Ensure the main power switch on front
panel is turned off .
2 . Connect one end of a 1/4" cable to one
of the ¼" mixed output on the rear panel
of the UHF-5816 .
3 . Connect the other end of the 1/4" cable to the desired input on your mixer or amplifier .
Outlet
Rear Panel
Rear Panel
10
Rear Panel
Mixer (not included)
Mixer (not included)