Quick Start - VocoPro CDG-600RF Owner's Manual

Quick Start

CONNECTING A TELEVISION MONITOR
If you will be connecting the CDG-600RF to a television or monitor, use the RCA video
connector wire included. On the back of the player, locate the yellow-coded RCA connector jack labeled VIDEO
OUTPUT and connect either end of the RCA connector wire. Connect the other end to your television or monitor.
There should be an RCA connector jack, just like the one on the back of the player, labeled VIDEO INPUT.
Connecting this wire will enable your television monitor to display the graphics that are encoded on CDG Karaoke
discs.
R L
3RD MIC BASS TREBLE
- + - +
EXT OUTPUT SPEAKER
EXT INT
SPEAKER SELECT
VIDEO VIDEO
INPUT OUTPUT
L L
www.vocopro.com
R R
AUX DVD LD PRE OUT IN
Professional Equipment
OUTPUT EFFECT LOOP
nouser serviceable parts inside AUDI0 INPUT TERMINAL
NOTE: If your television does not have an RCA type connector, use the built-in RF Modulator on the
CDG-600RF to connect your TV or monitor. (See "Connection Diagram" and "Trouble Shooting Guide" for
options.)
SUPPLYING POWER TO THE CDG-600RF
IMPORTANT! Be sure all your components i.e., amplifier, TV monitor, etc. are connected to the CDG-600RF
BEFORE connecting to a power source and powering on. Be sure to use caution when plugging in any electrical
appliance. Connect the power cord attached to the back of the CDG-600RF player into any wall outlet or surge
protector.
CONNECTING A MICROPHONE
1. Connect the microphone cable's 1/4" plug into either of the microphone jacks on the front panel of the
CDG-600RF amplifier player or use the KJ/DJ microphone input on the rear panel.
IMPORTANT! Before connecting a microphone, be sure the microphone volume is turned to a minimal setting.
When the microphone is plugged in and the unit is on do not point the microphone directly towards the speakers
or leave an unattended microphone too close to the speakers when the volume is up. This can create a loud
squeal called "feedback" which is very annoying and could possibly damage your speakers.
PLAYING CD/CDG's
1. Locate the "OPEN/CLOSE" button on the front of the CDG-600RF player.
2. Press once to open the CD tray. The tray will open automatically after the button is pressed.
3. Lay the CD/CDG on the open tray and press the "OPEN/CLOSE" button again. The tray will close automatically
after the button is pushed. IMPOR
DAMAGE THE UNIT.
STARTING THE CD PLAYER
1. Locate the "PLAY/PAUSE" button above the CD tray.
2. Press once to start the CD. Pressing the "PLAY/PAUSE" button will play song selection #1 on the CD/CDG
disc. The song will automatically begin playing after a few seconds.
TO PLAY A DIFFERENT SELECTION
1. Locate the "NEXT" button above the CD tray. Press the button until the number of the desired song selection
appears in the LCD display window
NOTE: You may hold down the button continually to advance the song selections.
7
ECHO
110-120V 220-240V
SWITCH TO:
NTSC FOR U.S. TV SYSTEM
PAL FOR EURO TV SYSTEM
VIDEO ONLY
NTSC PAL
VOLTAGE SELECT
CH3 VIDEO SYSTEM
AC 200W FUSE
AC T3A 250V
NTSC RF OUTPUT
AC 120/230v
50/60HZ
OUTLET
400VA MAX
UNSWITCHED
CALIFORNIA U.S.A
TANT: DO NOT PUSH THE TRAY CLOSED MANUALLY, AS THIS COULD
.
TV/MONITOR
VIDEO IN