Before Getting Started - VocoPro CDG-600RF Owner's Manual

Before Getting Started:

It is very important to read the following instructions prior to starting any installation
procedures. Doing so will ensure a correct installation and may save you some time as well.
Protect Against Power Surges
• Connect all external components before you plug any of their power cords into the
wall outlet.
• Turn off the CDG-600RF before you connect or disconnect any cables.
• Make sure all cables are properly grounded.
Protect Components from Overheating
• Don't block ventilation holes. Arrange any components so that air can circulate freely.
• Don't stack components.
• If you place the CDG-600RF on a stand, make sure you allow adequate ventilation.
Position Cables Properly to Avoid Audio Interference
• Insert each cable firmly into the designated jack.
• If you place components above the CDG-600RF, route all cables down the side of the
back of the CDG-600RF instead of straight down the middle of the back of the
CDG-600RF.
Important Stand and Base Safety Information
Choose the location for your CDG-600RF carefully. If the CDG-600RF is placed on a stand
or base, ensure that it is of adequate size and strength to prevent it from being accidentally
tipped over, pushed off, or pulled off. This could cause personal injury and/or damage to the
CDG-600RF.
You should have received the following items:
CDG-600RF
Remote Control
Pack of AAA Batteries
AC/DC Adaptor
5
Things to Consider
(1)
(1)
(1)
(1)
CDG-600RF DIGITAL KEY CONTROL CD/CD+G CASSETTE KARAOKE PLAYER
PLAYER 1
RECORDER
REC PLAY PLAY REW FFWD ST/EJ Pause
Digital key Display
Tape counter Reset
+ 2 0 0 : 0 0
Open/Close Disp Repeat Memory Previous Next
SHOCK RESISTANT PICK UP
POWER
b L L #
DIGITAL KEY CONTROL VOC/C VOC/P CASSETTE
OPEN/CLOSE
DISPLAY
MEMORY REPEAT
SKIP/SEARCH
STOP PLAY/PAUSE
5
Remote
Sensor
Music
0
level
B-scan F-scan Stop
-10 +10
Bass Music
0 10
Mic 1 level
Remote
Mic 1
CDG LD DVD AUX
Input Key
Control
10
-10 +10
Treble
0 10
Mic 2 level
Mic 2
Input