VocoPro CDG-600RF Owner's Manual page 10

Quick Start
FAST FORWARD AND REVERSE
1. To advance your selection while it is playing, for example to the next verse or chorus, locate the "F-SCAN" and
hold it down until you find the desired location.
2. To rewind your selection whiled it is playing, locate the "B-SCAN" key and hold down until you find the desired
location.
NOTE: When using this feature the words may become jumbled on your TV monitor if a CDG track is in
progress. In this scenario, digital graphics information does not process as rapidly as audio signals. Therefore,
the video signal will have to "catch up" to the audio signal. The screen will "refresh" on it's own.
BALANCING YOUR MIX
1. It is best to begin by first setting the music volume at a comfortable level for the room in which you are using
your CDG-600RF . The number of people in a room will generally have an effect on the acoustics and how
much volume will be needed.
2. Once the desired music volume is achieved, test each microphone volume individually by speaking or singing
into the microphone, holding it approximately two inches away from your mouth.
3. Adjust the volume control(s) for each microphone until an equal mix of music and vocals can be heard.
Remember to allow for vocal variances in each song where it may be necessary to sing louder or softer
TURN ON THE CDG-600RF
1. Locate the power switch on the front of the CDG-600RF player. Press the power switch once to turn on the
machine.
2. Locate the CDG button below the CDG tray. This selects the mode you will use the player in.
3. Carefully increase the volume by turning the large volume knob clockwise until the desired volume is reached.
4. Carefully increase the microphone volume until desired volume is reached.
ADDING BASS OR TREBLE TO THE MUSIC
1. Locate the small MUSIC BASS and TREBLE control knobs on the front panel of the CDG-600RF.
2. To add bass to the music, turn the MUSIC BASS knob clockwise until you have added the desired amount of
bass to the music. Likewise to remove bass, turn the knob counter-clockwise.
3. Perform the steps above for MUSIC TREBLE adjustments.
ADDING BASS OR TREBLE TO THE VOCALS
1. To increase the bass on the vocal signal(s) turn the MIC BASS control knob in a clockwise motion until the
desired amount of bass is achieved. Likewise to decrease the amount of bass on the vocal signal(s), turn in a
counter-clockwise motion.
2. Perform the steps above for MIC TREBLE adjustments.
ADDING ECHO TO THE VOCAL SIGNAL
1. The "ECHO" control knob is located on the back of the CDG-600RF player. (See diagram). Turn the knob in a
clockwise motion until the desired amount of ECHO is achieved on the vocal signal.
preference by the singer . The more ECHO that is used the "thinner" the voice sounds.
.
This is usually a
8