Table of Contents
Advertisement
CONNECTIONS
IR REPEATER CONNECTION
NOTE:
To operate components not made by Pioneer, perform REMOTE SET UP (page 33) after connecting an IR Repeater.
control of other components.
There are two kinds of infrared repeaters. Connect either or both to match the remote control requirements of different
components.
MAIN-REPEATER
Use this to operate other components with this unit's remote
control or to operate using GUI on-screen indications.
Install on top of this unit as shown in the figure.
MAIN-REPEATER
@ Insert the REPEATER's two
pegs into the holes on thetop.
@ Install the REPEATER laying
on its side on the top.
The pegs are usually
inserted in the two
rear holes.
Use the two front holes when
there's another component
on top of this preventingeasy
reception
of the
MAIN
REPEATER's infrared signals.
MINI-REPEATER
Use this when a component operates incorrectly after receiving
VSX-99
a signal from this unit's remote control, or when it is difficult for
:
a component to receive signals from the Main-Repeater. Stick it
Service Center.
|
=
——
o ==,
@ Remove the seal.
@ Stick onto the remote control
sensor window.
NOTE:
Before connecting the MAIN-REPEATER or MINI-REPEATER, switch power to the unit OFF, and wait
for about one hour. (When power is ON, the rear panel may become very hot.)
9
<ARBIO 51>
Advertisement
Table of Contents
