Table of Contents
Advertisement
Connecting Other Equipment
Connecting two VCRs (not equipped with an S video output jack) for tape editing
(Front of TV)
VCR
(for playback)
mt)
iE
VMC-810/S820S (not supplied)
Preparing for use
1. Turn on the TV.
2 Press TV/VIDEO on the TV or on the Remote
Commander so that "VIDEO 1," "VIDEO 2" or "VIDEO 3"
appears on the screen.
VIDEO 1: for equipment connected to VIDEO 1 IN
VIDEO 2: for equipment connected to VIDEO 2 IN
VIDEO 3: for equipment connected to VIDEO 3 IN
Notes
e
If you try to use equipment that is connected to the front
CAMCORDER/VIDEO 3 INPUT and rear VIDEO 3 IN jacks at the
same time, the picture will be distorted. Be sure you turn off one
piece of equipment first.
{f you have connected to a Camcorders input jacks, do not
connect to the TV's input jacks.
If you connect equipment to the rear VIDEO 3 IN S VIDEO jack,
you cannot receive the output signal from the VIDEO 3 OUT
VIDEO jack.
18 | Chapter 1: Setting Up
as
VMC-810/S820S (not supplied)
Watching a different image while duplicating
The VIDEO 3 OUT jacks only output the signal from
VIDEO 3 IN.
If you connect a VCR for playback to the VIDEO 3 IN jacks,
and a VCR for recording to the VIDEO 3 OUT jacks to
duplicate your recorded tapes, you can watch input images
different from the image being output for recording.
To watch a different input image
Press TV/VIDEO on the TV or on the Remote Commander
to select the input image you want to watch.
Advertisement
Table of Contents
