Table of Contents
Advertisement
Watching Two Pictures at Once (PIP)
Of at-tale|iaremmdar-muaiarelehy me) (eadel coma) olen alanrele(=
Follow these instructions to select the input mode
(TV/ VIDEO 1, VIDEO 2, VIDEO 3) for the window picture.
Remote Commander (inner panel)
CHINDEX
POSITION
PIP
®
®@ O ©
SPLIT
AUDIO
SWAP
OFF
—CH——
TVNIDEO REPLAY
OS
PICTUR
1 Press PIP to display a window picture.
LU
VV
Vv
VY
PIP
Press TV/VIDEO to select the input mode.
Each time you press TV/VIDEO, "TV," "VIDEO 1," "VIDEO 2"
and "VIDEO 3" appear in sequence.
TVNIDEO
To receive the window picture sound
Press AUDIO.
The > display appears for a few seconds, indicating that the
window picture sound is being received.
To restore the main picture sound
Press AUDIO again.
Note
The window picture sound is also output from the AUDIO (VAR)
OUT jacks. The AUDIO OUT and MONITOR OUT jacks output the
main picture sound only.
40
| Chapter 3: Using Advanced Features
Displaying CATV input as a window picture
To use Picture-in-Picture with pay cable TV input, make the
connections to your cable converter box as shown below.
(Front of TV)
<>:
Signal flow
Seccevcesecccccaone,
VMC-810S/820S
(not supplied)
After making the above connections, tum the cable
connection on by following the steps on pp. 24 — 25; then
continue with the steps below.
picture input mode" on this page to select the
1
2 Follow steps 1 - 2 in "Changing the window
=
video input mode for your connected VCR.
3 Put your VCR on an inactive channel (channel 3 or 4).
4 Change pay cable TV channels with the decoder box.
To control your cable converter box with the supplied
Remote Commander
See p. 72.
Advertisement
Table of Contents
