Table of Contents
Advertisement
Using the Programmable Remote Commander
Operating a cable converter box
While pressing CODE SET, press 6 and 8 (Zenith's
Follow these instructions to set the manufacturer's code,
code number — see Fig. 8) and ENTER.
which will enable you to operate a connected cable
converter box with the pre-programmed Remote
CODE SET
Commander.
Gr)
Example: Operate a connected Zenith cable converter box.
+
i
Remote Commander (Outer panel)
A long beep sounds, indicating that the code has been set.
Tve+caneaox
POWER
Note
If you press a wrong code, or if the code has not been set, four
=
5 Z
f
O
short beeps sound. Repeat step
2 to set the code.
TVNIDEO
G) @) @)
O
Use the TV contro! buttons (POWER, 0 - 9, ENTER
@) )
6)
3 and CH +/-) to operate the cable converter box.
®Q®®Oo
POWER
@@O
&
OISPLAY
JUMP
0) ©
©
at
(9)
Qe
999
0000
i, & tr
CODE SET
ORS,
To return to the normal screen
Set the TV/CABLE BOX selector to TV; then use the TV
control buttons to control the TV.
For more details on operating the cable box
Refer to the operating instructions that come with the
cable box.
Fig. 8: Cable box manufacturer code numbers
JERROLD
60, 61, 62, 63, 64, 65
SCIENTIFIC ATLANTA
TOCOM
71,72
ZENITH
ee
|
1 Set the TV/CABLE BOX selector to CABLE BOX.
Tve
CABLE BOX
enue.
Notes
¢ If more than one code number is listed, try entering them one by
one, until you come to the correct code for your equipment.
¢ If you enter a new code number, the code number you previously
entered at that setting is erased.
¢ In some rare cases, your equipment may use a code that is not
provided with this Remote Commander and you may not be able
to operate your cable converter box with the supplied Remote
Commander. In this case, use the equipment's own remote
contro! unit.
72
| Chapter 3: Using Advanced Features
Advertisement
Table of Contents
