Table of Contents
Advertisement
Connecting and Installing the TV (continued)
Connecting two VCRs for tape
editing using MONITOR OUT
MONITOR OUT gives you the ability to use a
second VCR to record a program being played
by the primary VCR or to perform tape
editing and dubbing.
1
Connect the VCR intended for playback
using the connection instructions on page
8 of this manual.
2
Using AUDIO/VIDEO connectors,
connect AUDIO and VIDEO IN on your
VCR intended for recording to MONITOR
AUDIO and VIDEO OUT on your TV.
Notes:
• Do not change the input signal while
editing through MONITOR OUT.
• When connecting a single VCR to the TV;
if VCR LINE OUT is connected to TV
VIDEO IN, do not connect the TV
MONITOR OUT jacks to the VCR LINE
INPUT (see right). Doing so will cause
program interference and other viewing
problems.
12
Disconnect all power sources before making any connections.
VCR (for playback)
AUDIO R AUDIO L VIDEO
OUT
LINE
IN
OUT
1
VMC-810S/820S (not supplied)
(Rear of TV)
VIDEO IN
MONITOR
OUT
VCR
LINE
IN
OUT
(Rear of TV)
VIDEO 1
VIDEO 3
MONITOR
IN
IN
OUT
S VIDEO
VIDEO
VCR (for recording)
L
(MONO)
AUDIO R AUDIO L VIDEO
AUDIO
R
VHF/UHF
(VER/FIX)
1
3
2
VMC-810S/820S (not supplied)
Indicates direction
of signal
OUT
LINE
IN
IN
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
Advertisement
Table of Contents
