Clearances - Reduced Clearance Connector - Travis Industries Lopi Rockport NexGen-Hybrid Owner's Manual

Stove Installation
Clearances – Reduced Clearance Connector
© Travis Industries
(for qualified installers only)
8/15/2023 -1593
NOTE: Measure rear and side stove
clearances from the nearest edge of the
stove top.
NOTE: Measure front floor protection
from the face of the stove (unibody).
NOTE: Reduced clearance connectors
may require an appliance adapter to
connect to the flue collar.
NOTE: Standard residential installations
with reduced clearance connector may
use the clearance determined by the
manufacturer of the connector for the
connector to wall clearance or the
clearance listed in this manual. Offsets
must be used to maintain the stove to
wall clearance.
NOTE: Vent diameter varies depending
on brand and model.
NOTE: Masonry chimney Applications
must utilize a positive connection (full
reline).
NOTE: Reduced clearance installations
require one of the chimneys and
connectors listed below:
• AMERI-TEC model DCC with model HS
chimney
• DURAVENT model DVL with DURATEC or
DURA-PLUS chimney
• GSW Super Chimney Twenty-One
connected directly to appliance
• I.C.C. Excel (2100-2 Can.) (103-HT USA)
chimney with ULTRABlack connector
• METALFAB model DW connector with TG
chimney
• OLIVER MACLEOD PROVENT model PV
connector with model 3103 chimney
• SECURITY model DP or DL connector with
SECURITY model ASHT or S2100 chimney
• SELKIRK METALBESTOS model DS
connector with model SSII chimney
• Standard Masonry Chimney with any one of
the above-listed connectors
Rockport NGH
9