Preparations; Connections - Aiwa XR-M99 Operating Instructions Manual

PREPARATIONS
CONNECTIONS
Before connecting the AC cord
The rated voltage of your unit shown on the rear panel of the
MX-LM99 Stereo Integrated Amplifier is 120V AC. Check that
the rated voltage matches your local voltage.
IMPORTANT
* Connect the speakers, antennas, and all optional equipment
first. Then connect the AC cord.
* Both speakers can be connected as L (Left) or R (Right).
When placing the Compact Disc Player at the side of the Stereo
Integrated Amplifier, make sure that the flat cable does not
obstruct the ventilation openings at the rear of the Stereo
Integrated Amplifier.
Always leave adequate clearance between the flat cable and the
ventilation openings.
Ventilation openings
7 Connect the Stereo Integrated Amplifier and the
Compact Disc Player to the Stereo Tuner.
Connect the flat cable of the Stereo Integrated Amplifier to
the FROM AMP terminal, and connect the flat cable of the
Compact Disc Player to the FROM CD terminal.
Push the connectors until they click into place.
Note that there is only one possible direction to plug in the
connectors.
@@ Stereo Tuner
Se
——
Compact Disc
Player
Flat cable
2 Connect the speaker cords to the speakers.
Connect the cords with the white stripes to ® terminals and
the other cords to © terminals.
6 ENGLISH
3 Connect the speaker cords to the Stereo
Integrated Amplifier.
The cords with the white stripes should be connected to the
@ terminals and the other cords to the @ terminals.
4 Connect the supplied antennas to the Stereo
Tuner. .
Connect the FM antenna to the FM 75 Q terminals and the
AM antenna to the AM LOOP terminals.
FM antenna
5 Connect the AC cord to an AC outlet.
Do not short-circuit the @ and © speaker cord leads; otherwise
the sound may become inaudible or the system may be turned
off.
If this happens, disconnect the AC cord from the AC outlet and
re-connect the speaker cords correctly. Connect then the AC
cord and turn the system on again.
To stand the AM antenna on a surface
Fix the claw to the slot.
To position the antennas
FM feeder antenna:
Extend this antenna horizontally in a T-shape and fix its ends to
the wall.
AM loop antenna:
Position to find the best direction.