Installation; Location Of Ice Machine; Leveling The Ice Machine - Welbilt Manitowoc NEO UDF0140A Installation, Operation And Maintenance Manual

Undercounter ice machines
Hide thumbs Also See for Manitowoc NEO UDF0140A:
Table of Contents

Advertisement

Available languages

Available languages

Location of Ice Machine

The location selected for the ice machine must meet the
following criteria. If any of these criteria are not met, select
another location.
• The location must be indoors.
• The location must be free of airborne and other
contaminants.
• The air temperature must be at least 40°F (4°C), but must
not exceed 110°F (43°C).
• The location must not be near heat-generating
equipment or in direct sunlight.
• The location must be capable of supporting the weight of
the ice machine and a full bin of ice.
• The location must allow enough clearance for water,
drain and electrical connections in the rear of the ice
machine.
• The location must not obstruct airflow through or
around the ice machine (condenser airflow is in and
out the front). Refer to the chart below for clearance
requirements.
• The location must not be near garbage or other
contaminants.
• The ice machine must use legs.
Self-Contained
Location
Top/Sides
5 (127 mm)
Back
5 (127 mm)
NOTE: The ice machine may be built into a cabinet. There
is no minimum clearance requirement for the top or left
and right sides of the ice machine. The listed values are
recommended for efficient operation and servicing only.
Part Number: 040005890 Rev 01 06/18
Self-Contained
Air-Cooled
Water-Cooled
5 (127 mm)
5 (127 mm)
Section 2

Installation

Series
Ice Machine
UF0140
UF0190
UF0240
UF0310
* B.T.U./Hour
** Because the heat of rejection varies during the ice making
cycle, the figure shown is an average.
Ice machines, like other refrigeration equipment, reject heat
through the condenser. It is helpful to know the amount of
heat rejected by the ice machine when sizing air conditioning
equipment where self-contained air-cooled ice machines are
installed.

LEVELING THE ICE MACHINE

1. Screw the leveling legs onto the bottom of the ice
machine.
2. Screw the foot of each leg in as far as possible.
3. Move the ice machine into its final position.
4. Level the ice machine by using a level on top of the ice
machine. Turn each foot as necessary to level the ice
machine from front to back and side to side.
Ice Machine Heat of Rejection*
Air Conditioning**
2400
2200
2800
3800
Peak
2900
2600
3300
6000
11

Advertisement

Table of Contents
loading

Table of Contents