Table of Contents
Advertisement
Burner Set-up
Burner Installation
Burner Information
26
Vitorond 100, VR1 40 to 63, 161 to 245 Installation and Service
Refer to installation instructions supplied with
the burner.
Observe all instructions supplied with the burner.
Fuel
This boiler is for use with the #2 fuel oil burner supplied
by Viessmann only. Use only the fuel stated on the rating
plate of the burner.
WARNING
DO NOT USE GASOLINE, CRANKCASE DRAININGS
OR ANY OIL CONTAINING GASOLINE.
Beckett Oil nozzle
The Beckett burner for the VR1 63, 245 boiler is shipped
with factory setting and oil nozzle installed. For VR1 50,
196 boiler, replace installed nozzle with nozzle packaged
with burner. For Beckett burner specifications see table
on page 41.
Riello Oil nozzle
The Riello burner for the VR1 33, 140 boiler is shipped
with factory setting and oil nozzle installed, and should
require only minor adjustments. For VR1 40,161 and 50,
196 boilers, replace installed nozzle with nozzle packaged
with burner.
For Riello burner specifications see table on page 41.
Carlin Oil nozzle
The Carlin burners for the VR1 boilers are shipped with
factory setting and oil nozzle installed. For Carlin burner
specifications refer to the Carlin burner supplement for
Viessmann and the table on page 42.
Burner calibration
Ensure that the combustion results of the oil-fired burner
mounted on this boiler are verified after start-up.
If adjustments are necessary, always verify results with
a calibrated flue gas analyzer.
IMPORTANT
This burner is shipped with the oil pump set to operate
on a single line system. To operate on a two-line system,
the bypass plug must be installed. The burner is shipped
configured for use in single line applications. No changes
to the oil pump are required for use in single line
applications.
Advertisement
Table of Contents
