Page 1
VIESMANN Installation and service instructions for contractors Vitocell 100-E/100-W Type SVWA Heating water buffer cylinder VITOCELL 100-E/100-W Please keep safe. 6150632 GB 3/2020...
Safety instructions Safety instructions Please follow these safety instruc- tions closely to prevent accidents and material losses. Safety instructions explained Danger Note This symbol warns against the risk Details identified by the word "Note" of injury. contain additional information. Please note This symbol warns against the risk of material losses and environmen- tal pollution.
Please note Repairing components that fulfil a safety function can compromise the safe operation of the system. Replace faulty components only with genuine Viessmann spare parts. Auxiliary components, spare and wearing parts Please note Spare and wearing parts that have...
Page 4
Index Index Information Disposal of packaging ................Symbols ....................Intended use ..................Product information ................Vitocell 100-E/100-W, type SVWA ............■ System examples .................. Spare parts lists ..................Preparing for installation Unpacking and handling ................ Connections ................... Installation sequence Cylinder installation ................Cylinder incl.
Information Disposal of packaging Please dispose of packaging waste in line with statu- tory regulations. Symbols The steps in connection with commissioning, inspec- Symbol Meaning tion and maintenance are found in the "Commission- Reference to other document containing ing, inspection and maintenance" section and identified further information as follows: Step in a diagram:...
Vitocell 100-E: Vitosilver electric heating (immersion heater) Vitocell 100-W: White Capacity: 200 l System examples Available system examples: See www.viessmann- schemes.com. Spare parts lists Information about spare parts can be found at www.viessmann.com/etapp or in the Viessmann spare part app.
Page 7
Preparing for installation Unpacking and handling Fig. 1...
Page 8
Preparing for installation Connections Fig. 2 Front Fig. 3 Back cover Thermometer sensor retainer Air vent valve (EL) Female connection for immersion heater (EHE) Heating water flow 1 (HV1) to the heating circuits Clamping device 1 (SPR1) for cylinder temperature sensor Heating water flow 2 (HV2) from the heat generator Clamping device 2 (SPR2)
Installation sequence Cylinder installation Please note Note The thermal insulation must not come into con- Only use one or two of the adjustable feet to level the tact with naked flames. cylinder. At least one of the adjustable feet must Exercise caution when welding and brazing remain fully screwed in.
Page 10
Installation sequence Fitting the cylinder temperature sensor and thermometer sensor (if supplied) Fig. 6 Recess for thermometer cable Note The cylinder temperature sensor is supplied in the control unit pack. 01. Insert the cylinder temperature sensor as far as it 06.
Page 12
Product characteristics Product characteristics Vitocell 100-E/100-W, type SVWA Cylinder capacity Standby heat loss kWh/24 h 1.39 with 45 K temperature differential...
Accessories Specification for immersion heater Rated output in standard mode Rated voltage 3/N/PE 400 V/50 Hz Rated current Heat-up time from 10 to 60 º Content that can be heated by the immersion heater...
Page 14
Disposal Final decommissioning and disposal Viessmann products can be recycled. Components For decommissioning the system, isolate the system and substances from the system are not part of ordi- from the power supply and allow components to cool nary household waste.
Certificates Declaration of conformity We, Viessmann Werke GmbH & Co. KG, D-35107 Using the serial number, the full Declaration of Con- Allendorf, declare as sole responsible body that the formity can be found on the following website: named product complies with the European directives www.viessmann.co.uk/eu-conformity...