Set-up
Insulation Installation
14
Vitorond 100, VR1 40 to 63, 161 to 245 Installation and Service
(continued)
3.
If installing Vitotronic control:
Run the fA plug-in connector cable of the Vitotronic
control down behind the front panel of the boiler
and out through the bottom.
4.
Install support brackets A.
5.
Position left side panel onto support brackets A.
6.
Line up bottom tab of side panel with notch in
casting leg of rear section.
7.
Once side panel is in place, bend down tab using
pliers as shown.
8.
Install rear insulation blanket to cast iron block,
black side facing outward.
9.
Install rear panel.