Pioneer VSX-9500S Operating Instructions Manual page 20

TUNER
FREQUENCY PRESETTING
1 ACOUSTIC
SELECT switch
switch
1. Press the POWER switch to the ON position.
NOTE:
Be sure to turn the TAPE 2 MONITOR switch OFF when listening to
AM or FM broadcasts.
2. Set the BAND selector to either FM or AM.
3. Tune in the desired station.
* See the section "DIRECT ACCESS TUNING" for information on
reception using the Direct Access Tuning mode.
* See the section "AUTO TUNING" for information on reception
using the Auto Tuning mode.
* See the section "MANUAL TUNING" for information on reception
using the Manual Tuning mode.
In addition to station frequencies, the following iterns can also be preset.
* FM MODE AUTO/MONO (FM)
* Acoustic setting (FM, AM)
4, Press the MEMORY switch.
5. Press the STATION CALL switch into which you wish to preset
the station.
© Use the STATION CALL switches (*1 — *0) to select a STATION
CH. One press selects the 1 -- 10 range, two presses 11 — 20
and three presses 21 — 30.
(Example) {f you press key | *3]:
One time — STATION 3
Two times ~ STATION 13
Three times — STATION 23
6. Repeat steps 2 to 5 to preset additional stations.
A total of 30 AM and FM stations may be preset. If you preset a
STATION CALL switch into which a station has already been
memorized, the former station information will be erased and the
new station will be memorized in its place.
20
<ARB1173>
3 4 FM MODE
AUTO/MONO
LISTENING TO BROADCASTS USING PRESET
TUNING
1. Press the POWER switch to the ON position.
2. Press the STATION CALL switch into which the desired station
has been preset.
* Use the STATION CALL switches {* 1 — *O} to select a STATION
CH. One press selects the 1 -- 10 range, two presses 11 — 20
and three presses 21 — 30.
{Example} H you press key
One time — STATION 3
Two times —~- STATION 13
Three times — STATION 23
* When the INPUT SELECTOR is set to a function other than
TUNER, it will switch to the TUNER function automatically if one
of the STATION CALL switches is pressed.
Tuning can be performed simply and accurately following the above
procedure.
3. Adjust the MASTER VOLUME and tone as desired.
NOTE:
The contents of the STATION CALL switch will be preserved for several
days, even if the receiver power cord is unplugged.
if 2 preset station has been erased, preset it again.
Last station memory
When the POWER switch is pressed to turn power on, the last station
received before the power was turned off will be tuned in again.
When the power is ON, if one of the BAND selector switches is pressed,
the last station received on that band will be tuned in again.