Table of Contents
Advertisement
4. Verify belt and insert are installed properly. Do not install the insert backwards.
Item
1
2
3
5. Pull belt tight and secure belt to clamp with set screws.
6. Torque set screws 300-350 lb-in.
7. Turn the Increment Weight Adjusting Knob to select 0 lbs or 0 kg.
8. Place weight stack pin in each plate to verify proper installation.
9. Simulate normal operation by lifting top weight up and down without selecting any resistance.
10. Verify that the belt is moving smoothly and is routed straight from the top pulley bracket to the top weight belt clamp.
Install back panel
Slide back panel down into extrusions.
Install top cover
1. Install screws securing top mount to frame using a Phillips screwdriver.
Correct belt routing
Description
Belt
Insert
Belt clamp
Item
1
2
3
Page 14 of 24
Incorrect belt routing
Qty.
1
1
1
Description
Screw
Top mount
Back panel
Qty
6
1
1
Advertisement
Table of Contents
