Table of Contents
Advertisement
Inspect grips for looseness or wear.
Inspect all labeling for readability, including instructional
placards, warning and caution decals.
Inspect all weight stacks for proper alignment and operation.
Inspect guide rods for lubrication.
Yearly Procedures
Replace all cables and belts annually
Belt Adjustment
Tools Required
•
7/32" Wrench
•
Torque wrench
1. Loosen set screws using a 7/32" Allen wrench.
2. Pull belt tight.
3. Secure belt in place with set screws.
4. Torque set screws to 300-350 lb-in.
5. Verify that the belt is moving smoothly and is routed straight from the top pulley bracket to the top weight belt clamp.
Inspection
Replace all loose or worn grips immediately.
Replace all worn labeling immediately.
Correct all improper alignment and operation issues
immediately.
Wipe Weight Stack Guide Rods clean over entire length. Lubricate
with a light coat of medium weight automotive engine oil.
Item
1
2
Page 20 of 24
Action
Description
Set screw
Belt
Qty
2
1
Advertisement
Table of Contents
