Table of Contents
Advertisement
4. Lean guide rods slightly outward, away from machine. DO NOT put excessive pressure on guide rods, it will damage lower guide
rod caps.
5. Slide top weight up and out of the machine and set aside.
6. Remove weight plates and set aside for re-installation later.
7. Move to desired location.
Install weight plates
1. Lean guide rods slightly outward, away from machine, DO NOT put excessive pressure on guide rods, it will damage lower guide
rod caps.
2. Wipe the entire length of the guide rods with a clean cloth.
3. Lubricate the guide rods with a light coating of medium weight oil.
4. Install each weight plate, one at a time, so wide edge of bushing faces upward (1) and narrow edge of bushing (2) faces downward.
Correct: Wide bushing edge upward
5. Slide top weight onto guide rods.
6. Install compression spring and top guide rod cap onto guide rod. Slide spring loaded top guide rod cap down guide rod until cap
is clear of guide rod plate and install. Repeat for opposite side.
7. Install four Phillips head screws securing plastic mount to guide rod plate.
Incorrect: Narrow bushing edge downward.
Item
1
2
3
Page 12 of 24
Description
Top guide rod cap
Guide rod
Guide rod plate
Qty
2
2
1
Advertisement
Table of Contents
