VINCENT SA-T7 Diamond Instructions For Use Manual page 27

1
2
1. TREBLE
Knob for setting the treble proportions (high frequen-
cies) of the sound. The middle position keeps the high
tones unchanged.
2. POWER
This is the main power switch for turning on and off
the device. The preamplifier is separated from the
mains voltage when switched off and cannot be set
into a standby state.
3. BASS
Knob for setting the bass proportions (low frequen-
cies) of the sound. The middle position keeps the bass
unchanged.
4. TONE
If deactivated, audio signals bypass the tone control
that has been set with the BASS and TREBLE dials.
5. Display window for the tube
6. SR: sensor diode for the remote control
FRONT VIEW
3 5
4 6
7
8
7. INPUT: Input Selector
This dial allows you to choose one of the six inputs.
The LED that is actually lit shows you what input chan-
nel has been selected. Additionally these LEDs show
that the appliance is switched on.
8. Analog/Digital
Button to choose between analog and digital inputs.
For further information see page 38.
9. VOLUME: Volume dial
This is the knob for the adjustment of the main
volume level of the system. The LED in this dial is blin-
king for some seconds while after switching on the
tubes are being warmed up or while the preamplifier
is muted.
10. LOUD: MUTE
Press this button to mute your system's loudspeakers
as an effect of muting the signals of the preamplifier
output "OUTPUT" (15) and the recording output
"REC OUTPUT" (12). After pressing this button again
the original volume level is being restored.
9
10
27