Safety Guidelines - VINCENT SA-T7 Diamond Instructions For Use Manual

This appliance was produced under strict quality controls.
It complies with all established international safety standards.
Nonetheless, the following instructions should be fully read and
Do not open the appliance! Risk of electric shock!
There are no parts in the appliance that require maintenance by the user.
Maintenance/Alterations
All equipment that is connected to the domestic mains
voltage can be dangerous to the user if not handled
properly. Leave maintenance work to qualified profes-
sionals. The product is only permitted for connection
to AC 230Volt/50Hz, for earthed sockets and use in
enclosed areas. Altering the product or manipulating
its serial number voids the warranty. After a fault, lea-
ve the appliance's fuse to be replaced only by a pro-
fessional with one of the same kind.
Power Cable Connection
Always pull the plug and never the power cable if
you want to disconnect the appliance from the mains
power. Make sure when setting up the appliance
that the power cable is not squashed, severely bent or
damaged by sharp edges. Do not touch the power lead
with wet or damp hands. Use the power cable supplied
or another one from Vincent.
Switching Off
Switch the appliance off every time before you con-
nect or remove other components or loudspeakers,
disconnect or connect it to the mains power, leave it
unused for a longer period or want to clean its out-
si-de. On all amplifiers and receivers, wait approx. 1
minute after this before disconnecting or reconnecting
the cable.
Moisture/Heat/Vibration
Contact of electrically operated equipment with li-
quids, moisture, rain or water vapour is dangerous
for such equipment and the user and must be avoi-
24

SAFETY GUIDELINES

observed in order to prevent any hazard:
ded without fail. Take care that no liquids or objects
get inside the appliance (ventilation slots etc.). It must
be disconnected from the mains power immediately
and examined by a professional if this happens. Ne-
ver expose the appliance to high temperatures direct
sunshine or strong vibration.
Heat Build-up
Make sure that a gap of 5 cm remains around the ap-
pliance and that the surrounding air can circulate (do
not install in enclosed cupboards). Vents must not be
covered up.
Volume
The maximum tolerable volume is always rea-
ched well below the maximum possible setting on
the amplifier. Be careful with the volume setting,
therefore, in order to prevent damage to hearing.
So that you do not expose yourself to high volumes
unintentionally, always set to a low level before
changing the input channel.
Cleaning
Pull out the power plug before cleaning the outside
of the product. Whenever possible, use a soft, lint-free
cloth that has been dampened. Do not use abrasives,
solvents, thinners, flammable chemicals, polishes and
other cleaning products that leave marks.
Batteries
Take note of the instructions for using batteries in the
chapter „Remote Control".