Table of Contents
Advertisement
Note
Different series products may support different manufactures, please refer to the actual
product.
CAM name: Set the channel name and then click Save button.
Note
Make sure you have successfully added the remote device and the connection status is
if you want to change channel name. .
IP address: Input remote device IP address.
RTSP port: Input RTSP port of the remote device. The default setup is 554.
Note
Skip this item if the manufacture is private or customize.
HTTP port: Input HTTP port of the remote device. The default setup is 80.
Note
Skip this item if the manufacture is private or customize.
TCP port: Input TCP port of the remote device. The default setup is 37777.
User name/password: The user name and password to login the remote device.
Channel No.: Input channel amount or click the Connect button to get the channel
amount of the remote device.
Note
We recommend click Connect button to get remote device channel amount, the manual
add operation may result in failure if the input channel amount is not right.
Remote channel No.: After getting the remote device channel amount, click Setup to
select a channel.
Note
Click to select one or more remote channel numbers here.
Channel: The local channel number you want to add. One channel name has
corresponding one channel number.
Decode buffer: There are three items: realtime,local,fluent.
Service type: There are four items: auto/TCP/UDP/MULTICAST(ONVIF device only)
Note
The default connection mode is TCP if the connection protocol is private.
There are three items:TCP/UDP/MULTICAST if the connection protocol is ONVIF.
There are two items: TCP/UDP if the connection protocol is from the third-party.
16
Advertisement
Table of Contents
