Panasonic K-NL408KT/G Quick Start Manual page 10

The rear panel is shown as in Figure 2-2.
Please refer to the following sheet for detailed information.
Icon Port Name
Network port
High
HDMI
Media Interface
USB3.0 port
RS-232
RS-232
COM.
VGA video output
VGA
port
MIC IN Audio input port
MIC OUT Audio output port
Alarm input port
1～4
1～4
GND GND
NO1,NO2
Alarm output port
1～2
C1,C2
A
RS-485
communication
port
B
Function
10M/100M/1000Mbps
Connect to the network cable.
High definition audio and video signal output port. It
transmits uncompressed high definition video and
Definition
multiple-channel data to the HDMI port of the display
device. HDMI version is 1.4.
It displays Screen-1.
USB3.0 port. Connect to mouse, USB storage device,
USB burner and etc.
debug It is for general COM debug to configure IP address or
transfer transparent COM data.
VGA video output port. Output analog video signal. It
can connect to the monitor to view analog video.
It displays Screen-2.
Bidirectional talk input port. It is to receive the analog
audio signal output from the devices such as
microphone, pickup.
Audio output port. It is to output the analog audio signal
to the devices such as the sound box.
Bidirectional talk output.

Audio output on 1-window video monitor.

Audio output on 1-window video playback.

There are two types; NO (normal open)/NC (normal

close).
When your alarm input device is using external

power, please make sure the device and the NVR
have the same ground.
Alarm input ground port.
2 groups of alarm output ports. (Group 1 ： port

NO1 ～ C1,Group 2:port NO2 ～ C2).Output alarm
signal to the alarm device. Please make sure there
is power to the external alarm device.
NO：Normal open alarm output port.

C：Alarm output public end.

RS485_A port. It is the cable A. You can connect to the
control devices such as speed dome PTZ.
RS485_B.It is the cable B. You can connect to the
control devices such as speed dome PTZ.
5
Figure 2-2
self-adaptive Ethernet port.