Changing The Hydraulic Filter - Toro 25545T Operator's Manual

Changing the Hydraulic Fluid (continued)
6. Remove the bolts securing the tank straps.
7. Remove the hydraulic tank.
8. Flush the reservoir with cleaning solvent.
9. Remove the elbow adapters and clean the
filter screens with compressed air.
Note:
adapters.
10. Apply thread sealant to the threads of the
suction screen and install the screen, elbow,
hose, and clamp.
11. Connect the electrical lead to the fluid
temperature sensor.
12. Connect the hose to the tank and secure with the clamps.
13. Install the hydraulic tank assembly.
14. Fill the tank.
15. Install the dipstick cap.
16. Start the engine and allow it to run for a few minutes.
17. Shut off the engine.
18. Check the hydraulic fluid level.
19. Add fluid as needed to keep the level at the line on the dipstick.

Changing the Hydraulic Filter

1. Lower any attachments, engage the parking
brake, shut off the engine, and remove the key.
2. Turn the filter counterclockwise, remove and
discard it.
3. Apply a thin coat hydraulic fluid to the rubber
gasket on the replacement filter.
4. Fill the filter with clean fluid.
5. Install the replacement filter. Tighten it
clockwise until the filter contacts the filter head,
then tighten the filter an additional 3/4 turn.
6. Start the engine and let it run for about 2
minutes.
7. Shut off the engine and check for leaks.
Maintenance: Hydraulic System Maintenance
Make a note of the orientation of the
G416162
G416160
Page 7–21 3467-222 A