Toro 25545T Operator's Manual page 71

Charging the Battery (continued)
3. Connect the red positive (+) jumper cable
clamp to the positive (+) post
in the disabled machine.
4. Connect the other red positive (+) jumper
cable clamp to the positive (+) post of battery
in the service vehicle.
5. Connect the black negative (-) cable clamp to
the negative (-) post of battery
vehicle.
6. Connect the other black negative (-) cable
clamp to the engine or frame ground on the
disabled vehicle, at least 31 cm (12 inches)
from the failed battery.
7. Charge the battery for 1 hour at 25 to 30 A or 6
hours at 4 to 6 A.
Do not overcharge the battery.
8. Remove the jumper cables from the service vehicle, black negative (-) clamp first. Do
not allow the clamps to touch.
3467-222A
of the battery
in the service
IMPORTANT
G003792S
Page 7–10
G289502S
Positive battery post
Negative battery post
Red (+) charger lead
Black (-) charger lead
Maintenance: Electrical System Maintenance