Installing With Pc Dvr Series - Hitron FASTRAX II Instruction Manual

RS232/RS485
RS232
RS485
6. After setting Unit ID, Camera, and RS232/RS485, installing dome camera is basically completed. Please
refer to the manual of DVR for the other installation.
7. Press the related number of the controller which is correspondent to unit ID of DVR. Then press DVR
button and adjust unit ID of the controller
8. Make sure if any change is appeared on screen when you press
testing. If there's no change appeared, verify cable connection and setting of installation.
2.7 Install with PC DVR Series
22 AWG UTP CABLE
J-BOX(FRONT)
PTZ Control from DVR
If user wants to connect with PC DVR, please proceed as the following order.
1. Connect RS-232C cable between RS-232C Port of PC DVR and DVR port of the J-box. (This connection
enables PC DVR control remotely from KBD controller)
2. Connect 8pin Multi cable between the data2 port of the KBD and the J-BOX.
3. Plug the RS-232C TO RS-485 converter in the RS-232C Port of PC DVR. Connect wires between the
TX(+/-) of converter and DOME2(+/-) of J-Box. (This connection enables PC DVR PTZ control from KBD
controller)
4. How to setup the KBD controller.
A. Switch the KBD controller ON
B. Input password (Factory Setting is 9 9 9 9)
Baud Rate Parity
9600 None
9600 None
J-BOX(REAR)
Remote Control
DATA2 DATA1
RS-232C to RS-485
CONVERTER
Figure 11 – PC DVR Connection Diagram
Data Stop
8 1
8 1
button of the controller for basic
WIRE CONNECTION
DOME JUNCTION BOX
R(T)X+ DOME1 +
R(T)X- DOME1 -
CONVERTER JUNCTION BOX
TX+(RS-485)
DOME2 +
DOME2 -
TX-(RS-485)
RS-232 CABLE
21
Usage
Remote Control
PTZ Control
IDR SERIES