Table of Contents
Advertisement
FASTRAX-2L Vxxx
Slave ID = 1
Input Password : xxxx
CAM:000
3. Press CTRL + MENU. Set the Slave ID to 01
4. Set Slave Mode to "B" in case that master keyboard model is HID2404CLx(N : NTSC,P : PAL) and to "B"
in case HID2404CDx
Slave ID = 1
Slave Mode : A/B
2.6 Install with Standalone DVR Series
22 AWG UTP CABLE
J-BOX(FRONT)
PTZ Control from DVR
DVR1 or DVR2 can be set by following method though the menu system and screen are different.
If user wants to connect with DVR, proceed as the following order.
1. Connect RS232 cable between RS-232 Port of DVR and DVR port of the J-box. (This connection
enables DVR control remotely from KBD controller)
2. Connect 8pin Multi cable between the data2 port of the KBD and the J-BOX.
3. Connect wires between the TX(+/-) of DVR and DOME2(+/-) of J-Box. (This connection enables DVR
PTZ control from the keyboard controller)
Current Device ID = 1
Default setting is 9999 for administrator, 1111 for user
000 means that the controller is not connected to the master keyboard
A : HID2404CLx,HID2404CZx or HID2404CEx, B : HID2404CDx
J-BOX(REAR)
Remote Control
ADR SERIES
DATA2
DATA1
Figure 9 – DVR Connection Diagram
18
WIRE CONNECTION
DOME
JUNCTION BOX
R(T)X+
DOME1 +
R(T)X-
DOME1 -
ADR
JUNCTION BOX
TX+
DOME2 +
DOME2 -
TX-
RS-232 CABLE
RX+
RX-
TX+ TX-
RS-485
Advertisement
Table of Contents
