Table of Contents
Advertisement
2.3 Multiplexer Configuration
Duplex setup:
NOTE:
Multiplexers to be controlled by the keyboard controller require a new ROM version. The new
multiplexer ROM accepts control instructions from the keyboard controller. If your multiplexer's serial
number is M104xxxx or higher, then it is ready to accept control instructions. Alternately, you can check
the status of your multiplexer by pressing the Menu key of the multiplexer and then selecting item 9. If
you see the "** Protocol" option line in the Communication Setup menu, your multiplexer has the new
ROM, and you do not need to replace the ROM. If your multiplexer has the old ROM version, contact
your distributor on how to get new a ROM.
CAUTION:
Before opening the multiplexer, make certain you are working on an antistatic work
surface and that you are wearing a grounding wrist strap. Also, be very careful to orient
the ROM chip correctly and not bend any of the pins.
NOTE:
Replace the multiplexer firmware with the new multiplexer ROM (U45) as follows;
Remove the top cover of the multiplexer, and locate the ROM (U45). Before removing the ROM, note
the orientation of the ROM. After removing the old ROM from the socket, insert the new ROM.
Be careful to orient the new ROM the same as the old ROM.
(Refer to the Multiplexer instruction manual.)
Set the multiplexer functions as follows:
(Press the Menu key of the multiplexer to enter the Unit Options menu.)
9. Unit Options
Unit Number:
Communication Type:
Baud rate:
PORT:
** Protocol:**
** The old ROM version does not show Protocol selection option.
Multiplexer alarm inputs will function normally, but the Dome controller has no way of knowing about
alarms wired to the Multiplexer. If a Dome preset is required for such an alarm, you must connect the
same alarm input to both the multiplexer and Dome.
Triplex setup:
Network Type:
Baud Rate:
Unit address:
Protocol: B1
NO
SETTING
On
1
Off
On
2
Off
On
3
Off
4~6
-
On
7
Off
8
--
Table 1 - S1 Switch Setting
001 (first Mux) or 002 (second Mux)
RS 485
9600 bps
ON
B (If you see this line, the multiplexer has the new ROM)
Unit setup
RS 485
9600 bps
001 ~ 128
15
DISCRIPTION
DOME1 Termination
Mux/Slave Termination
DOME2 Termination
Reserved
Slave
Master
Reserved
Advertisement
Table of Contents
