Table of Contents
Advertisement
4 BUTTON REMOTE TRANSMITTER:
#1
LOCK/
ARM
#3
AUX. 1
ACTIVE ARMING
To arm the alarm and lock the doors, press the #1 Button on either
transmitter. You will hear a single siren chirp and the lights will
flash once. The system will arm, the doors will lock (optional) and
the starter will be disabled. The red in-dash LED in the vehicle will
begin to flash. After a short delay of 10-15 seconds to allow vehicle
and electronics to stabilize the system will be completely armed.
ALARM TRIGGERING
If there is an intrusion into the vehicle such as an open
door/hood/trunk, the alarm siren will sound and flash the lights for 1
minute. This is known as a cycle. After the cycle, the system will
automatically reset and continue to protect the vehicle. If a door is
left open then the unit will cycle for the Maximum of 5 minutes,
reset, and continue to protect the other un-tampered zones.
DISARMING
To disarm the alarm and unlock the doors, press the #2 Button on either transmitter. You will hear 2 siren chirps and
the lights will flash twice. The in-dash LED stops flashing dome light turns on. (Optional) If the alarm is tripped, then
the #2 Button will have to be pressed twice. The first press will reset the trigger and the second press will Disarm.
OPERATION
#2
UNLOCK/
DISARM
SLNT
AUX
C
S
RIM E
TOPPER
#4
SILENT/
AUX. 2
SECURWATCH® TRANSMITTER:
BUTTON 1
BUTTON 2
BUTTON 1 + 2
= BUTTON 4
(NO BUTTON 3
WITH WATCH)
Advertisement
Table of Contents
