Table of Contents
Advertisement
OPERATION
ALARM CYCLE RESET
If and when the alarm system is triggered, pressing the #2 button on either transmitter will reset the unit's cycle (lights,
siren) condition without disarming it. Pressing the button a #2 button second time will Disarm/Unlock the system.
REMOTE AUX. OUTPUT 1 (OPTIONAL,)
Note: AUX 1cannot be operated with the SecurWatch transmitter if the alarm system is programmed for
Carjack protection. To activate an optional feature such as a trunk/hatch pop (if vehicle is properly equipped), press
Button #3 (AUX) on the 4-Button CoolGlow remote or press and hold Button #2 (when disarmed) on the SecurWatch®
transmitter. This provides a ½ second auxiliary pulse to activate a relay for power trunk release or other optional
feature. (Extra parts and/or labor may be required for this feature.)
REMOTE PANIC PROTECTION
To sound the alarm upon command (panic), press and hold the Button #1 on either transmitter for at least 3 seconds
until the siren sounds and lights flash. Press Button #2 to reset the panic mode.
ARMING WITHOUT SHOCK SENSOR
To arm the alarm without Shock sensor protection, press Button #1 as normal then press and hold Button #4 (SLNT)
for about 3 seconds until the unit flashes the lights 3 times indicating shock sensor bypass. (Button #1, then 1+2
w/Watch)
SHOCK / IMPACT PROTECTION WITH PRE-WARNING
Once the system is armed, if a low-level shock to the vehicle body is detected, the pre-warning sensor activates with 5
siren chirps and one light flash as a Warn-Away feature. If a hard impact to the vehicle is detected the system will go
into a full trigger cycle for 20 seconds. Adjust the shock sensor as needed by turning the control knob clockwise or
counter-clockwise to increase or decrease the sensitivity. Shock sensors will "settle in" over time and it may take a few
tries over a few weeks to get the adjustment correct for your vehicle. We recommend a moderate adjustment where
the vehicle is protected but it is not constantly triggering from the slightest vibration therefore creating a nuisance.
EMERGENCY OVERRIDE/DISARM
If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to open the
door with the key, (activating the alarm), turn the ignition ON, press and hold the override/program until the system
disarms (about 7 seconds). The Alarm will disarm allowing you to operate the vehicle until you can repair/replace the
remote transmitter.
VALET MODE
To put the Alarm system into valet mode for vehicle service or otherwise, turn the ignition on and press the Button #4
(SLNT) on the remote until lights flash 3 times. The in-dash LED turns on solid. Repeat the procedure to exit VALET
mode. The system will chirp 3 times and the LED will turn off on Valet mode exit. Lock/Unlock and AUX features will
still operate in when in VALET mode. (IGN ON, then Buttons 1+2 w/Watch)
Advertisement
Table of Contents
