Seats, Head Restraints - Volkswagen Transporter 1972 Instruction Manual

8
www.vw-t2-bulli.de

Seats, head restraints

Driver's cab
To move the driver's seat to or fro
Pull the lever at the front of the seat upwards
and slide the seat to the required position.
To adjust driver's seat backrest rake
By turning the hand wheel the backrest rake
can be adjusted to any required angle.
To adjust the front passenger seat
Lift the seat at the front until the backrest
becomes unhooked from the retainer on the
partition. Then lift the seat out of the retaining
brackets. With the seat folded, insert it into
the required position on the retainer brackets.
When lowering the front of the seat ensure
that the backrest hooks properly into the
retainer.
Head restraints
To remove:
Pull upwards.
To install:
Push in until the head restraint comes to a
stop.
Having adjusted the seat to the required
position release the lever and allow it to latch
into position again so that the seat does not
move while driving.
Note: The seat can be completely pushed out
when the adjusting lever and the stop spring
— rear on the left hand seat runner — are
lifted at the same time.
Behind the driver's or passenger's seat there
is a bracket for the warning triangle. On ve-
hicles with a full-width cab rear panel the
triangle can be placed under the passenger
seat.
The head restraints must be pushed down
fully to the stop. They are not adjustable.