Remote Engine Control - CrimeStopper The Informer II CS-2016FM Operation Instructions Manual

REMOTE ENGINE STARTING - SUCCESSFUL START
1) Press remote start button on the remote transmitter. System will chirp 3 times for audible confirmation.
(Chirps can be programmed on or off-See installation manual.)
2) Parking lights flash once, then turn on solid, Ignition/Accessory circuits turn on.
3) After a few seconds, Starter Motor engages, Parking lights and Accessory circuits turn off while cranking.
4) Engine Starts and Runs. Parking Lights and Accessory turn back on, Doors Lock.
5) Engine will remain running for programmed run time until reset with Brake pedal. If needed, the engine can
be turned off with remote transmitter.
REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM:
FLASH 1X
START
THEN
SOLID
REMOTE ENGINE STARTING – LCD PAGER-REMOTE:
When requesting a remote start the LCD pager remote
will confirm with an Ignition Icon along with 4 beeps.
Once the vehicle has successfully started the remote will
confirm back with 2 vibrations, a moving vehicle Icon, and
4 beeps.

REMOTE ENGINE CONTROL

AFTER
IGN
SEC.
9
3
STARTER
IGN
PM
CONFIRM REMOTE
START REQUEST
SOLID
IGN
(<<<< MOVING <<<<<)
PM
SUCCESFUL START