Pioneer VSX-D2S Operating Instructions Manual page 4

BEFORE OPERATING, ADJUST THE POSITION OF THESE SWITCHES
TWO VOLTAGE SELECTOR SWITCHES
Only multi-voltage models are provided with these switches.
U.S., Canadian, European, U.K., and Australian models are not
provided with these switches.
Main voltages in Saudi Arabia are 127 V and 220 V only. Never
use this model with 110 V setting in Saudi Arabia.
The line voltage selector switches are on the rear panel. Before your
model is shipped from the factory, these switches are set to the
power requirements of the destination. Check that they are set
properly before plugging the power cord into the household wall
socket. if the voltage is not properly set or if you move to an area
where the voltage requirements differ, adjust the selector switches
as follows.
1. Use a medium-size screwdriver.
2. First, insert a screwdriver in the groove of the voltage selector at
the right, and adjust so that the tip of the groove points to the
voltage value of your area.
3. Next, insert a screwdriver in the groove of the voltage selector at
the left and adjust until the voltage is the same as at the right.
TWO VOLTAGE SELECTORS
110V 220V
120V-127V T 240v
Lf
Ka
Vv 240V
MOV 120V-127V
2)
i-<
fe)
e
1?)
wy
a
a
WwW
QO
<
i
8
>
Medium-size
screwdriver
ACCESSORY ITEMS
al
FM T-type Antenna
AM Loop Antenna
4
"<ARB1455>
CAUTION: TWO VOLTAGE SELECTORS
PAP
120¥-127v x
r c (aa
NOTE:
Both switches must be in the same switch
setting; otherwise, unit can be damaged.
Audio/Video programmable
remote control unit
CHANNEL STEP/FM DE-EMPHASIS SWITCH
(Not available on U.S. and Canadian models)
The unit has been factory-preset to the channel allocation and de-
emphasis value for the area in which it is to be sold. if these values
{
i
i
|
|
are set incorrectly, the frequency display may stop at the wrong |
frequency, or sound may be distorted, resulting in an inability to -
reproduce reception signals at their proper sound quality. For this
reason, be sure to confirm that the values are set correctly before
first using the unit.
\
[FM 100 kHz/75 ps, AM 10 kHz] position:
Setto this position for areas with an FM reception step of 100 kHz, de-
emphasis 75 ps and AM 10 kHz.
[FM 50 kHz/50 us, AM 9 kHz] position:
Set to this position, for areds with an FM reception step of 50 kHz, de-
emphasis 50 us and AM 9 kHz.
NOTE:
When unsure about the channel allocation and de-emphasis values
of your area, consult your dealer for correct information.
50kH:
/50uS
100kHz
1OkHz /75pS
a a
AM FM
CHANNEL
STEP/
FM DE-
EMPHASIS
(va
y
4
ON S
SNS
Ker
YES
N
Alkaline dry cell battey x 2
(size "AA" (LR6/AM-3)