APRILIA SR 50 Workshop Manual page 31

PERIODIC MAINTENANCE
Chronometer function
Quickly press the MODE joystick to start the chronometer.
If the MODE joystick is pressed before 10 seconds have
elapsed since chronometer start, current measure is
cancelled and a new one is started.
If the MODE joystick is pressed after 10 seconds have
elapsed since chronometer start, current measure is
stopped, stored and a new one is started.
Hold down MODE joystick for a certain time to stop the
measurements.
It is possible to store up to 16 times in a row, that can be
displayed on the CHRONOMETER screen under the Menu
function (see "Menu Function").
Menu function
Press the MODE joystick for a certain time to enter the
Menu. Press again the MODE joystick to access the
SETTINGS, CHRONOMETER,
LANGUAGE sub-menus.
•
SETTINGS sub-menu: this menu allows:
- Time setting: (from the SETTINGS menu) briefly
press on MODE joystick to enter the setting function.
Set the time using the UP/DOWN joystick, confirm it with the
MODE joystick. Using UP/DOWN joystick shift to minutes,
confirm the set value with the MODE joystick .
- Code change: (from the SETTINGS menu) shortly
press on the MODE joystick to enter the function for setting
the 5-digit safety code.
Set the first digit using the UP/DOWN joystick, confirm it with
the MODE joystick. Then set the following digit.
CAUTION The safety code will be necessary to start the
vehicle with a key not fitted with a transponder or in any case
not initialised
The safety code stored on any new vehicle is 00000.
Every time a new vehicle is started, the instrument panel
issues a warning to prompt the rider to customise the safety
code. It is recommended to set the standard code with your
personal one, take note of the new code and keep it in a safe
place, not on the scooter itself and remember to hand it over
to the new owner in case of sale.
2 - 12
WWW.PlanDeGraissage.ORG
DIAGNOSTICS and
on the vehicle.
SR 50