APRILIA SR 50 Workshop Manual page 128

CYCLE PARTS
•
Remove the snap ring (1).
• Remove the pin (2).
• Remove the spring (3).
•
Remove the pads (4) sliding them out one at a time.
WARNING
Do not operate the brake lever when the pads
are not in place or the calliper piston might
come off its housing, thus causing brake fluid
leakage.
Always change both pads and ensure they are
correctly in place inside the calliper.
•
Fit two new brake pads (4).
•
Correctly seat the spring (3).
• Fit the pin (2).
• Fit the snap ring (1).
For front brake calliper only:
• Refit the brake calliper cover.
• Check the brake fluid level, see (BRAKING SYSTEM).
5 - 26
WWW.PlanDeGraissage.ORG
SR 50