Step 5: Wiring - Hunter TRAK WIRED Installation Manual

INSTALLATION
Electric Shock Hazard.
To prevent serious injury or death:
• BEFORE installing or servicing your fan, ALWAYS disconnect the power by turning off the circuit breaker
or breakers to the fan locations and confirm Lockout/Tagout procedures are in place.
• If you cannot lock the circuit breakers in the off position, securely fasten a prominent warning device,
such as a tag, to the electrical panel.
• All wiring must be in accordance with national and local electrical codes, including ANSI/NFPA 70. If
you are unfamiliar with wiring or in doubt, consult a qualified electrician.
A
Fully unscrew power connector. Place power cable and canopy ground wire through power connector end. Next, slide male power connector housing over wires. Using a small phillips head
screw driver, back off screws on one half of wire terminal. The ridged side of the power cable is the neutral and goes into the hole marked (N). The center wire from the power cable is ground.
Twist together with ground wire from canopy and insert into hole with ground symbol (
terminal screws securely to make wire connections. Repeat for wires from ceiling with female power connector housing and the other power connector end. To secure the power connector,
tighten male to female and then the connector ends by twisting clockwise. (all sections of the power connector)
Power Connector End
A
Ridged Side
K2
Downrod Wiring
Canopy Ground
Wire
16

STEP 5: WIRING

ELECTRIC SHOCK HAZARD
Power
Male Power
Connector Center
Connector Housing
N
L
Power Connector
Center Wiring Engaged
). The outer wire without ridges is the Live (L) and goes into the hole marked (L). Tighten down all
Female Power
Connector Housing
N
L
Ceiling Wiring
Power Connector
End
Power Cable Sealed
K