Step 2: Downrod - Hunter TRAK WIRED Installation Manual

INSTALLATION
A
Place the preassembled
downrod (E) through the
canopy(I) and upper motor
housing (J).
A
I
J
C
Power Cable

STEP 2: DOWNROD

B
Place the bottom of the downrod into
the bracket of the fan while aligning
the holes. Make sure power cable
is facing the power port to ensure a
connection. Place a bolt through each
hole and secure each bolt with a nut.
E
E
CAT5 Ethernet Cable
C
Connect the power cable from
the downrod to the fan.
Connect the CAT5 Ethernet cable
(communication cable) from the
downrod to the fan.
B
I
Large End
J
x2
F
D
F
D
Attached the secondary hanging cable
to the fan by threading the cable eye
through the upper slot of the motor
shaft. Attach the D-shackle to the wire
as shown and secure by screwing
the pin through unthreaded wall of
shackle and the cable eye into the
threaded wall of shackle until it is
tight.
E
E
Motor Shaft
Upper Slot
F
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make sure
bolts are securely tightened and shackle is secure.
13