Table of Contents
Advertisement
14 After Finishing Work
13.3
Mowing
The cutting height is determined by the distance
of the cutting attachment from the ground.
Mowing with a mowing head (A)
► Swing the brushcutter steadily back and forth
in an arc.
► Walk forward slowly and steadily.
Mowing with a grass cutting blade (B)
► Mow with the left part of the metal cutting
attachment.
► Walk forward slowly and steadily.
For optimum performance, observe the recom‐
mended temperature ranges,
13.4
Adjusting Nylon Line
13.4.1
Line Feed on AutoCut Mowing Heads
► Briefly tap the rotating mowing head on the
ground.
About 30 mm of fresh nylon line is advanced.
The line limiting blade in the deflector auto‐
matically cuts the mowing lines to the correct
length.
2
1
Automatic feed will not take place if the mowing
lines are shorter than 25 mm.
► Switch off the brushcutter and remove the bat‐
tery.
► Depress the spool (1) on the mowing head
and hold it depressed.
► Pull out the mowing lines (2) by hand.
► If the mowing lines (2) cannot be pulled out to
the required length: Replace the spool (1) or
the mowing lines (2).
The spool is empty.
0458-029-0101-A
A
21.4.
13.4.2
Line Feed on SuperCut Mowing
Heads
Mowing lines are advanced automatically. The
line limiting blade in the deflector automatically
cuts the mowing lines to the correct length.
B
Automatic feed will not take place if the mowing
lines are shorter than 40 mm.
► Switch off the brushcutter and remove the bat‐
tery.
► Pull out the mowing lines by hand.
► If the mowing lines cannot be pulled out to
required length: Replace the mowing lines.
The spool is empty.
14 After Finishing Work
14.1
After finishing work
► Switch off the brushcutter and remove the bat‐
tery.
► If the brushcutter is wet: Allow the brushcutter
to dry.
► If the battery is moist or wet: Allow the battery
to dry,
21.4.
► Clean the brushcutter.
► Clean the deflector.
► Clean the cutting attachment.
► Clean the battery.
► If a metal cutting attachment is attached:
Attach the appropriate transport guard.
15 Transporting
15.1
Transporting the brushcutter
► Switch off the brushcutter and remove the bat‐
tery.
► If a metal cutting attachment is mounted: Fit
the matching transport guard.
Carrying the brushcutter
► Carry the brushcutter in one hand properly
balanced by the shaft, with the cutting attach‐
ment behind you.
Transporting the brushcutter in the car
► Secure the brushcutter to prevent turnover
and movement.
15.2
Transporting the Battery
► Switch off the brushcutter and remove the bat‐
tery.
► Check that the battery is in a safe condition.
► Pack the battery in packaging in such a way
that it cannot move inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the Carriage of Danger‐
ous Goods regulations. The battery is classified
English
17
Advertisement
Table of Contents
