Stihl FSA 120.0 R Instruction Manual page 12

English
1
9
4
8
7
► Insert the pin (8) into the opening in the quick
release clamp (5).
Align the pin (8) so that the notch of the pin is
at the bottom.
► Place the clamp (3) in the loop handle so that
the holes are aligned.
► Place the loop handle (2) with clamp (3) on the
shaft (9).
► Insert the long screw (7) through the holes in
the pin and quick release clamp (5).
► Press the clamp (4) against the shaft so that
the holes are aligned.
► Insert the short screw (6) through the holes.
► Insert the long screw (7) through the holes.
► Screw on the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) is properly adjusted if it can
no longer be moved.
► If the loop handle (2) can be moved:
► Open the quick release clamp (5).
► Tighten the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) can no longer be
moved.
► If the quick release clamp (5) cannot be
closed:
► Open the quick release clamp (5).
► Loosen the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) can no longer be
moved.
8.2 Attaching the barrier bar
► Switch off the brushcutter and remove the bat‐
tery.
12
2
3
5
6
4 3
2
1
► Place the barrier bar (2) on the loop han‐
dle (3).
The barrier bar should close flush with the
loop handle.
► Screw in and securely tighten the screw (1).
8.3 Mounting and Removing the
Deflector
8.3.1 Attaching the deflector
► Switch off the brushcutter and remove the bat‐
tery.
1
2
The line limiting blade (1) has already been
installed in the guard (2) and must not be
removed.
► Push the deflector (2) into the guides on the
gear housing up to the limit stop.
► Insert the screw (3) and tighten it securely.
8.3.2 Removing the Deflector
► Switch off the brushcutter and remove the bat‐
tery.
2
► Unscrew the screw (2).
► Pull off the deflector (1).
8.4 Mounting and Removing the
Mowing Head
8.4.1 Mounting the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
8 Assembling the Trimmer
3
4
1
0458-029-0101-A
2