Table of Contents
Advertisement
WHAT IS TRAIL CONTROL
WARNING: The system does not
control speed in low traction conditions
or extremely steep slopes. The system
is designed to be an aid and does not
relieve you of your responsibility to drive
with due care and attention. Failure to
follow this instruction could result in
personal injury.
WARNING: The system does not
replace the parking brake. When you
leave your vehicle, always apply the
parking brake.
Trail control lets you focus on steering
during low-speed and off-road use by
controlling your vehicle's acceleration and
braking to maintain the speed that you set.
You may hear a noise from the anti-lock
brake system pump motor when you use
the system. This is normal.
TRAIL CONTROL LIMITATIONS
Trail control is unavailable when any of the
following occur:
•
Your vehicle speed is greater than
20 mph (32 km/h) in two-wheel drive
high (2H), four-wheel drive auto (4A)
or four-wheel drive high (4H) modes.
•
Your vehicle speed is greater than
9 mph (15 km/h) in four-wheel drive
low (4L) mode.
•
Your vehicle speed is greater than
5 mph (8 km/h) in reverse (R).
•
The transmission is in park (P).
•
The driver side door is open.
•
Cruise control is on.
•
The parking brake is applied.
2024 Ranger (TRD) Canada/United States of America, enUSA, Edition date: 202304, DOM
Trail Control - Raptor
235
SWITCHING TRAIL CONTROL
ON AND OFF
Press the Trail Control on the
touchscreen. See Using the
E272858
Off-Road Screen (page 372).
The system switches off if you press the
button again or exceed 42 mph (68 km/h).
SETTING THE TRAIL CONTROL
SPEED
Note: The buttons are located on the
steering wheel.
Drive to your preferred speed.
Press the toggle button up to
increase the set current speed.
E246884
Press the toggle button down to
decrease the set current speed.
E246885
Note: The indicator changes color.
You can adjust the set speed in small or
large increments. Press the toggle button
up or down once to adjust the set speed
in small increments. Press and hold the
toggle button up or down to adjust the set
speed in large increments.
You can also decrease the set speed by
braking.
Note: If a set speed is set, the trail control
is active and the vehicle is stopped by the
brake, releasing the brake allows the vehicle
to accelerate to the set speed. Pressing the
brake pedal does not switch off the system.
CANCELING THE SET SPEED
Press the button.
E350925
Advertisement
Table of Contents
Troubleshooting
