Table of Contents
Advertisement
E360006
3. Raise your vehicle until the tire is clear
of the ground.
4. Use the locking wheel nut key to loosen
the locking wheel nut.
5. Remove the lug nuts and the road
wheel.
Installing a Road Wheel
WARNING: Use only approved
wheel and tire sizes. Using other sizes
could damage your vehicle.
WARNING: Do not fit run flat tires
on vehicles that were not originally fitted
with them. See an authorized dealer for
more details about compatibility.
WARNING: Make sure there is no
grease or oil on the threads or the
surface between the wheel studs and
the wheel nuts. This can cause the wheel
nuts to loosen while driving.
WARNING: Have the wheel nuts
checked for tightness and the tire
pressure checked as soon as possible.
2024 Ranger (TRD) Canada/United States of America, enUSA, Edition date: 202304, DOM
Changing a Road Wheel
469
Note: Make sure the wheel and hub contact
surfaces are free from foreign matter.
Note: Make sure the cones on the lug nuts
are against the wheel.
1.
Install the wheel.
2. Install the lug nuts and finger tighten.
3. Install the locking lug nut key.
E79156
4. Lower your vehicle and remove the
vehicle jack.
5. Fully tighten all of the lug nuts in the
sequence shown. See Wheel Nuts
(page 470).
Stowing the Flat or Spare Tire
1.
Lay the tire on the ground, near the rear
of the vehicle, with the valve stem side
facing up.
2. Slide the wheel partially under the
vehicle and install the retainer through
the wheel center. If equipped, you may
have to remove the wheel center cap
prior to pushing the retainer through
the center of the wheel. To remove the
center cap, press it off with the jack
tool from the inner side of the wheel.
Pull on the cable to align the
components at the end of the cable.
3. Insert the handle into the guide hole
and engage the winch.
Advertisement
Table of Contents
Troubleshooting
