Table of Contents
Advertisement
About the Internal Pedal System
The GT-5 features a function called Internal Pedal System.
Using this system, you can control the value of the selected
parameter with the assumed expression pedal in real-time.
The Internal Pedal System features the following two func-
tions, allowing you to set "Source" for each Assign Number
(1 - 8) of the Control Assigns.
internal Pedal
Wave Pedal
Internal Pedal
With the trigger you have set, the assumed expression pedal
starts working. If you have set "Internal Pedal" to "Source,"
set the following parameters.
(Trigger)
This sets the trigger that activates the virtual expression pedal.
ASSIGH
1 X I-PDL
Tria:
CTL PEDAL
PatchChange:
This is activated when a Patch is selected.
EXP PEDAL-L:
This is activated when the Expression Pedal on the GT-5
is depressed. It starts working even when pressed only
slightly.
EXP PEDAL-M:
This is activated when the Expression Pedal on the GT-5
is depressed. It does not start working until the pedal is
depressed as deeply as up to the middle.
EXP PEDAL-H:
This is activated when the Expression Pedal on the GT-5
is depressed. It does not start working until the pedal is
depressed deep down.
CTL PEDAL:
This is activated when the Control Pedal on the GT-5 is
depressed.
EXT/CTL1:
This is activated when the pedal connected to the EXP/
CTL 1 jack is depressed.
EXT/CTL2:
This is activated when the pedal connected to the EXP/
CTL 2 jack is depressed.
MIDI Velo:
This is activated when the value of the Velocity messages
from an external MIDI device exceeds the middle value.
MIDI P.B.:
This is activated when the value of the Pitch Band
messages from an external MIDI device exceeds the
middle value.
MIDI CTL#01 - 31, 64 — 95:
This is activated when the value of the Control Change
messages (CC#01 — 31, 64 — 95) from an external MIDI
device exceeds the middle value.
(Time) (0 - 100)
This controls the time needed for the assumed Expression
Pedal to move from the returned (lifted) position to the
depressed (lowered) position.
ASSIGH
1
Time:
(Curve)
This selects one of the three types that determines how the
assumed Expression Pedal changes.
HSSIGH
i
I-PFDL
Lineat
upust
Linear
Slow Rise
Fast Rise
Wave Pedal
This changes the parameter selected as a target in a certain
cycle with the assumed Expression Pedal. When you have set
^Wave Pedal" for "Source," the following parameters should
be set.
(Rate) (0 - 100)
This determines the time spend for one cycle of the assumed
Expression Pedal.
(Waveform)
This selects one of the three types that determines how the
assumed Expression Pedal should change.
HSSIBH
1 — W-PDL
llavefarn:
SAL
SAW
TRI
SIN
Section 2 Modifying Various Settings
27
Advertisement
Table of Contents
