Setting The Expression Pedal Function - Boss RE-2 Owner's Manual

Setting the Expression Pedal Function

By connecting an expression pedal (such as the Roland EV-5, sold separately) to the CTL/EXP jack, you can operate the top panel
knobs aside from the [MODE] knob.
You can set the respective sounds for when the expression pedal is at MAX position (pushed all the way up with your toes) and at
MIN position (pushed all the way down with your heel), and make continuous changes to them.
* Use only the specified expression pedal. Connecting expression pedals made by third-party manufacturers may cause this
unit to malfunction.
1. With the power turned off (nothing should be plugged into the INPUT A jack), set the [MODE] knob to
"10".
2. While holding down the pedal switch, turn on the power (by connecting a plug to the INPUT A jack).
3. Use the respective knobs to set the sound that's used when the pedal is at the MIN value (pushed all the
way down with your heel).
4. Press the pedal switch.
5. Use the respective knobs to set the sound that's used when the pedal is at the MAX value (pushed all the
way up with your toes).
6. Press the pedal switch again to exit the settings.
Various Settings
9