Table of Contents
Advertisement
Using the Manual Mode
When the Manual Mode is turned on, the display shows the
name of the effect that corresponds to each pedal. You can
see if the Patch effect is turned on or off with the indicator (lit
or off) of each pedal in the Manual Mode. When you depress
a pedal, the relevant effect will be turned on or off.
* In the Manual Mode, the Bank pedal works as the On/Off selector
pedal for Tuner/Bypass.
Boo
Bob
BCE
HHF:
BTUHER
Setting the Manual Mode
The following shows how to set the Manual Mode. Select the
effect that should be assigned to each pedal.
(Procedure)
—
IND
NEL
:
GEEA
om
GJ
1
Movethe cursor to the pedal number for which you
wish to change the effect assignment using the
[PARAMETER].
dcs
BUD
BHR
EDD BCE
BTUMER
Cursor
2
Select the effect to be assigned using the VALUE
dial.
3
Repeat steps 1 and2
to assign the effects to other
pedals.
Utility Function Settings
The following pages explain the GT-5's Utility functions,
which allow you to configure the unit for the setup you are
using.
(Procedure)
ecc
xu
=
EISE
ESI
Sn
1
Press the [UTILITY] button several times to bring
up the parameter you wish to set. Each time you
press the button, the following items will be suc-
cessively selected.
* When you are setting the Utility functions, the indicator of
the button will be lit.
« 1: GLOBAL >
--- UTILITY -=-
1. GLOBAL
This function can temporarily change the settings
commonly for all the Patches.
< 2: METER >
=== UTILITY —-
2. METER
This function causes the display to show the output
level of the specified effect.
< 3: SYSTEM >
This function sets the basic system of the GT-5.
< 4: MIDI >
4. MIDI
Make settings related to MIDI.
< 5: HR SCALE (Harmonist scale) >
--- UTILITY —-
S.HR SCALE
Set the user scale for the Harmonist function.
Advertisement
Table of Contents
