Tremolo / Pan - Boss GT-5 Owner's Manual

TREMOLO / PAN
Effect Off, On
Mode Tremolo, Pan
Modulation Wave Square, Triangle
Rate 0 100
Depth 0 100
Balance L100:0R L0:100R
Tremolo is an effect that creates a cyclic change in volume.
Pan cyclically moves the stereo position between left and
right (when stereo output is used).
Effect
Turns the tremolo/pan effect on/off.
Mode
Selection for tremolo or pan.
Tremolo:
The volume will change cyclically.
Pan:
The sound will be moved cyclically between left and
right.
Modulation Wave
Selection for the waveform that the effect will use.
Square:
Abrupt change will be produced.
Triangle:
Smooth change will be produced.
Rate
Adjusts the frequency (speed) of the change.
Depth
Adjusts the depth of the effect.
Balance
Adjusts the stereo position of the sound.
54
REVERB
Effect Off, On
Reverb Time 0.1 10.0 sec
Pre Delay 0 100 msec
Low Cut Filter 55.0 800 Hz
High Cut Filter 700Hz - 11.0kHz, Flat
Density 0 10
Effect Level 0 100
This simulates the sound that reaches the listener after
being reflected from many surfaces (late reverberation).
Effect
Turns the reverb effect on/off.
Type
This selects the Reverb Type. Various different simulations of
space are offered.
Room 1:
Simulates the reverberation in a small room. Provides the
bright reverberation of a live room.
Room 2:
Simulates the reverberation in a small room. Provides
warm reverberations.
Hall 1:
Simulates the reverberation in a concert hall. Provides
clear and spacious reverberations.
Hall 2:
Simulates the reverberation in a concert hall. Provides
warm reverberations.
Plate:
Simulates plate reverberation (a reverb unit that uses the
vibration of a metallic plate). Provides a metallic sound
with a distinct upper range.
Reverb Time
Adjusts the length (time) of reverberation.
Pre Delay
Adjusts the time until the reverb sound appears.