Table of Contents
Advertisement
Your Setting ?: (P.12)
POWER Amp
EXP PEDAL
CONTROL 1
EXP PEDAL/
CONTROL 2
EV-5 (Roland)
EV-5 (Roland )
FV-300L
FV-300L
* When you connect an Expression pedal to the EXP/CTL jacks, be
sure to set the Minimum Volume to the "MIN" position.
* If connecting a footswitch (FS-5U; optional) to the EXP/CTL
jacks, set the polarity switch as shown below.
Polarity Switch
ER cn
|
0
m
h
Power-on and Standby
In order to take full advantage of the GT-5's performance, be
sure to make the following settings.
Power-on
Oncethe connections have been completed (p. 10— 11), turn
on power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
GT-5
External Effects Device
chiar Amplifier (Power Amplifier)
The following display will appear, and after several seconds,
the GT-5 will be ready for normal playing. This display is
referred to as the "Play page."
GROUP
BANK
"a 'g TUBE STACK
* When the power is turned on, the last-selected Patch number will
be selected.
* This unit is equipped with a protection circuit. A brief interval (a
few seconds) after power up is required before the unit will
operate normally.
Adjusting the Input Level
The level of the output signal differs between guitars. Use the
Input Volume knob to adjust the input level to suit your guitar.
BBOSS
„~
[rg
eR —
oun,
wor.
VOE
* — UMONO) monti
BENO RETURN
000:00C00
1
Play your guitar at the maximum loudness that you
will produce in normal playing.
2
Adjust the Input Volume knob until the OVERLOAD
Indicator lights briefly.
* The OVERLOAD indicator will light 6 dB before clipping level
(the level where distortion begins).
* If the input level is too high, the
GT-5 will not produce the desired
effects.
Section 1 Try out the GT-5
1]
Advertisement
Table of Contents
