Transmitting Data (Bulk Dump) - Boss GT-5 Owner's Manual

Transmitting Data (Bulk Dump)
« Connections »
When saving the data to a sequencer
Make connections as shown below, and set the sequencer to
a condition ready to receive exclusive messages.
i
"Eoompgocuu ©)
iU t
um. JL
| MIDI OUT -
MIDI IN
* For details on sequencer operation, refer to the manual for the
sequencer you are using.
When copying the data to another GT-5
Make connections as shown below, and set the Device ID of
both units to match.
BOG
GT-5 |
"ooooanaoa it
LJLJLJUJLJUJUC ann LJ ma
N
11 05 0 D 0] d
MIDI OUT
| MIDI IN
"Dpaggcug BE a
< Transmission Procedure >
3,4
|
= 7 2,3,4
eJ eS 4
65
1 Select "4.MIDI" with [UTILITY].
2 Use[PARAMETER] to access the following param-
eter (Bulk Dump) in the display.
Bulk fume
Len + Tene
Starting Point Ending Point
3 Move the cursor to "Starting Point" with [PARAM-
ETER], then select the data to be the starting point
with the VALUE dial.
4 Move the cursor to "Ending Point" with [PARAM-
ETER], then select the data to be the ending point
with the VALUE dial.
5 Press [WRITE] to transmit the data.
When the transmission has been completed, the previous
display will reappear.
6 Press [EXIT] to end the procedure.
Section 4 Using MIDI 6]